XC90 Twin Engine Cargo cover | Volvo Support AU

Installation1

Insert one of the cargo cover's end pieces in the recess in the side panel in the cargo area.

Then insert the other end piece in the recess in the side panel on the opposite side.

Press down the end pieces on both sides - one by one.

When a "click" is heard and the red marking on each end piece has disappeared, the cargo cover is attached - check that it is affixed securely.

Usage

There are two extended positions for the cargo cover - a full-cover position and a loading position, where it is partially extended to make it easier to reach further into the cargo area.

Full-cover position

For 7-seat car

Hang up the locking tabs of the seatbelts for the third seat row on the designated hooks in the side panels.

Grip the handle and pull out the cargo cover so that it slides over the side panels in the cargo area. Pull to the end position.

When the cargo cover is extended so that it covers the cargo area - guide the cover's attachment pins into the grooves in the side panels and release, while at the same time angling the handle with a light downward pressure.

The cargo cover is locked in the full-cover position.

For 5-seat car

Grip the handle and pull out the cargo cover so that it slides over the side panels in the cargo area. Pull to the end position.

The cargo cover is locked in the full-cover position.

Loading mode

From retracted position - grip the handle and pull out the cover so it slides over the side panels in the cargo area - pull to the end position and guide the cargo cover's attachment pins into the grooves in the side panels. (If the cover is already in the full-cover position - see the next point)

From full-cover position - grip the handle and guide the cargo cover's attachment pins into the grooves in the side panels and release.

Retract the cover until it stops in the loading position.

In the event that your hands are occupied:

In the extended full-cover position - lightly push the handle part of the cargo cover upward, e.g. with an elbow.

The cover retracts until it stops in the loading position.

To return to full-cover position from loading position:

Grip the handle and pull the cargo cover out to the end position.

Release slightly and angle the handle by means of a light downward pressure.

The cover is then locked in the end position.

Important

Do not load objects on top of the cargo cover.

Warning

In a 7-seat car, never have the cargo cover fitted when there are passengers in the rear seats. This may lead to serious injury in the event of a collision.

Retracting

From the full-cover position:

Lift up the handle and pull it backward to disengage the cargo cover's attachment pins and then release.

From loading position:

Grip the handle and pull out the cargo cover in the grooves - pull to the full-cover position. Lift up the handle and pull it backward to disengage the attachment pins and then release.

Retract the cover with its attachment pins outside of the side panels until it stops in the retracted position.

Removal

In retracted position:

Depress the button on one of the retracted cargo cover's end pieces and lift out that end.

In a 7-seat car - release the third seat row's seatbelt locking tabs from the hooks above the side panels.

Angle the cover up/out carefully.

The other end piece loosens automatically and the cover can be lifted out of the cargo area.