You can control some primary lighting mode behaviors using the left-hand steering wheel stalk.
You can move the left-hand stalk forwards or backwards to switch between different lighting selections. The stalk always springs back to the neutral position.
The selections available are:
- High beam on
- High beam off
- High beam flash
The default lights setting is automatic1.
When automatic lights mode1 is selected in the center display:
Push the left-hand stalk twice to switch between manual high beam and automatic high beam.
When passing beam is manually selected in the center display:
Push the left-hand stalk to turn manual high beam on or off.
High beam flash:
Pull the left-hand stalk towards you to activate the high beam flash.
The lights settings reset to their default values between drives.
Important
Make sure that the vehicle cameras are well-maintained and kept clean. If the cameras’ views are obscured by dirt, they will not be able to obtain enough information to properly direct the car’s lighting responses.