Front seats – power seat1
The power seat(s) can be adjusted for a short period after unlocking the door with the remote control without the key in the ignition slot. Seat adjustment is normally made when the ignition is on and can always be made when the engine is running.
Power seat
Front edge of seat cushion up/down
Raise/lower the seat
Seat forward/rearward
Backrest tilt
Electronic lumbar support*
Operation
Note
- Only one of the power seat's controls can be used at the same time.
- The power seats have an overload protector that activates if a seat is blocked by any object. If this occurs, switch off the ignition (key in position 0) and wait for a short period before operating the seat again.
Power seat memory function
- Button for storing a position
- Button for storing a position
- Button for storing a position
- M (memory) button
Programming the seat's memory
Three different seating and door mirror positions can be stored in the driver seat's memory.
The following example explains how button (1) can be programmed. Buttons (2) and (3) are programmed in the same way.
To program (store) a seat and door mirror position in button (1):
Move the seat (and door mirrors) to the desired positions using the seat and mirror adjustment controls.
Press and hold down the M (memory) button (4).
With the memory button depressed, press button (1) briefly to store the current position for the seat/mirrors.
To move the seat and mirrors to the position that they were in when a button was programmed:
Press and hold down button (1) until the seat and mirrors stop moving.
Note
As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the preset position.
Heated seats*
See Heated seats.