Tire sealing system* – overview

Certain models are equipped with a tire sealing system* that enables you to temporarily seal a hole in the tread surface and re-inflate a flat tire, or to adjust a tire’s inflation pressure.

P3/P4-1246-ALL-new version of TMK 1
  1. Ikon röd cirkel 1Speed limit sticker (on the rear side of the compressor)
  2. Ikon röd cirkel 2On/Off switch
  3. Ikon röd cirkel 3Electrical wire
  4. Ikon röd cirkel 4Bottle holder (orange cover)
  5. Ikon röd cirkel 5Protective hose cover
  6. Ikon röd cirkel 6Air release knob
  7. Ikon röd cirkel 7Hose
  8. Ikon röd cirkel 8Bottle with sealing compound
  9. Ikon röd cirkel 9Air pressure gauge

 Warning

Please keep the following points in mind when using the tire sealing system:

  • The sealing compound bottle (no. 8 in the illustration) contains 1) rubber latex, natural and 2) ethanediol. These substances are harmful if swallowed.
  • The contents of this bottle may cause allergic skin reactions or otherwise be potentially harmful to the respiratory tract, the skin, the central nervous system, and the eyes.

Precautions:

  • Keep out of reach of children.
  • Do not ingest the contents.
  • Avoid prolonged or repeated contact with the skin.
  • Wash thoroughly after handling.

First aid:

  • Skin: Wash affected areas of skin with soap and water. Get medical attention if symptoms occur.
  • Eyes: Flush with plenty of water for least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical attention if symptoms occur.
  • Inhalation: Move the exposed person to fresh air. If irritation persists, get medical attention.
  • Ingestion: Do NOT induce vomiting unless directed to do so by medical personnel. Get medical attention.
  • Disposal: Dispose of this material and its container to a hazardous or special waste collection point.

 Note

Do not break the seal on the bottle. This occurs automatically when the bottle is screwed into the holder.
  1. *Option/accessory.