Calibrating the tire pressure monitoring system*
In order for the tire pressure monitoring system, Tyre Pressure Monitoring System (TPMS), to function correctly, tire pressure reference values must be set correctly. This must be done each time the tires are changed or the tire pressure is adjusted.
Open the Car status app in App view.
Tap TPMS.
Note
Run the car until calibration is complete.
Calibration is done when the vehicle is driving at a speed above 35 km/h (22 mph).
When enough data has been collected for the system to detect low tire pressure, the color of the tire symbols in the center display will change from gray to green. The system will not provide any other confirmation that calibration has been completed.
If the car's ignition is switched off before calibration is complete, the tires in the center display change color from gray to green upon next start-up, even if calibration is not complete. Perform the calibration again and allow it to complete within the same operating cycle to ensure that the calibration is carried out correctly.
If start-up of calibration fails, the following message appears: Calibration unsuccessful. Try again..
Note
Always remember to calibrate the Tire Pressure Monitoring System when the wheels have been changed or the tire inflation pressure has been corrected according to the tire pressure decal or tire inflation pressure table.
If correct reference values have not been set, the system cannot issue low tire pressure alerts correctly.
The vehicle must be stationary with the engine running to access the calibration button and to start the calibration process.