Note
If the vehicle is equipped with a towbar, there is no rear attachment for the towing eye.
Attaching the towing eyelet
Take out the towing eyelet, which is stored in a foam block under the floor in the cargo compartment.
Remove the cover by pressing on the mark with a finger while folding out the opposite side/corner.
The cover turns along its center line and can then be removed.
Screw the towing eyelet in as far as possible.
Fasten the eyelet securing by, for example, inserting a lug wrench* through it and using this as a lever.
Important
It is important that the towing eye is screwed in securely as far as possible.
Removing the towing eyelet
Unscrew the towing eyelet after use and return it to the foam block.
Replace the cover on the bumper.