Installing a wheel

Instructions for installing a wheel during a wheel change.

 Note

The jack provided with your vehicle is intended to be used only in temporary situations such as changing wheels in the event of a flat tire. Only the jack that came with your particular model should be used to lift the vehicle. If the vehicle needs to be lifted more frequently or for a prolonged period, using a garage jack or hoist is recommended. Always follow this device's instructions for use.

 Warning

  • Apply the parking brake and put the gear selector in the Park (P) position.
  • Block the wheels standing on the ground, use rigid wooden blocks or large stones.
  • Check that the jack is not damaged, the threads are properly lubricated and it is free from dirt.
  • Be sure the jack is on a firm, level, non-slippery surface and that it is upright and not leaning.
  • The jack must correctly engage in the jack attachment.
  • No objects should be placed between the base of the jack and the ground, or between the jack and the attachment bar on the vehicle.
  • Never let anyone remain in the vehicle when it is raised on a jack.
  • If a tire must be changed near passing traffic, make sure all passengers move to a safe location.
  • Use a jack intended for the vehicle when changing a tire. For any other job, use stands to support the vehicle.
  • Never crawl under or allow any part of your body to be extended under a vehicle supported by a jack.
Clean the contact surfaces between the wheel and the wheel hub.

Lift the wheel into place. Tighten the wheel bolts securely.

Do not grease the wheel bolt threads.

Lower the vehicle so that the wheel cannot rotate.

Tighten the wheel bolts in a crisscross pattern (as shown in illustration). It is important that the wheel bolts are securely tightened. Tighten to a torque of 140 Nm (103 ft.lbs.). Use a torque wrench to check torque.

P5-1507- tightening wheel screws
Press the plastic covers onto the wheel bolts.

 Warning

The wheel bolts may need to be tightened again several days after a wheel change. Temperature fluctuations and vibrations can cause them to loosen slightly.

 Note

  • After inflating a tire, always replace the valve cap to help prevent valve damage caused by gravel, dirt, etc.
  • Use plastic valve caps only. Metal caps could corrode and become difficult to remove.

Related documents