Activating the parking brake
Tap the button.
The symbol in the instrument panel will illuminate when the parking brake is activated.
Automatic activation
The parking brake is applied automatically
- if the driver removes their seat belt and/or opens the driver's door.
- when the vehicle is switched off manually from the center display.
- if the Hold (automatic braking at a standstill) function is activated and the vehicle has been stationary for a long period of time (about 10 minutes).
Important
Make sure that the parking brake symbol is illuminated when leaving the vehicle.
Emergency braking
In an emergency, the parking brake can be activated when the vehicle is moving by pushing and holding down the button.
The brakes will then be applied with force in order to brake the vehicle. The braking process is canceled when the button is released or if the accelerator pedal is depressed.
Note
In case of emergency braking at high speeds, a signal sounds during the brake procedure.
Deactivating the parking brake
The parking brake is deactivated automatically when a gear position is selected.
Fasten your seat belt.
Depress the brake pedal.
Select gear selector position D or R
The parking brake will release automatically and the symbol in the instrument panel will go out.
Release the brake pedal.
If regenerative braking is activated, the vehicle will not move forward, but could begin rolling away if the ground is leaning in the same direction as the selected gear position.
If regenerative braking is deactivated, the vehicle will drive slowly in the selected direction if the accelerator pedal is pressed lightly.
Note
For automatic deactivation to be possible, the driver's seat belt must be buckled or the driver's door closed.
