The Start/Stop function is available when the ignition is started and can be activated if certain conditions are met.
- Available
- active
- not available.
All of the vehicle's ordinary systems, such as lighting, radio, etc. function normally when the engine has been auto-stopped. Certain functions may be temporarily reduced however such as the climate system's blower speed or extremely high audio system volume.
Auto-stop
To auto-stop the engine:
- Stop the vehicle by applying the brakes and keep the brake pedal depressed. The engine will auto-stop.
In Comfort or Eco drive mode, the engine may auto-stop before the vehicle has completely stopped.
With Adaptive Cruise Control or Pilot Assist activated, the engine will auto-stop about three seconds after the vehicle has stopped.
Auto-start
The following conditions must be met for the engine to auto-start.
- Release the brake pedal. The engine will auto-start and the vehicle can be driven. On an uphill gradient, Hill Start Assist (HSA1) will activate to help prevent the vehicle from rolling backward.
- When the Auto-hold function is activated, auto-start will be delayed until the accelerator is pressed.
- When Adaptive Cruise Control or Pilot Assist are activated, the engine will auto-start when the accelerator pedal is depressed or the
button on the left-side steering wheel keypad is pressed. - Maintain pressure on the brake pedal and press the accelerator pedal. The engine will auto-start.
- On a downhill gradient: Release the brake pedal slightly so that the vehicle begins to roll. The engine will auto-start after a slight increase in speed.
Symbols in the instrument panel
White – Displayed in the tachometer when the function is available.
Green – Shown in the tachometer when the function is active and the engine is auto-stopped.
Gray – When the symbol is grayed-out with a line through it, the function is not available.
If no symbol is shown, the function is switched off.
