If any condition is not met, this will be indicated in the instrument panel.
The engine does not auto-stop
The engine will not auto-stop if:
- The vehicle has not reached a speed of ca 10 km/h (6 mph) after starting.
- After several auto-stops, the speed must again exceed approximately ca 10 km/h (6 mph) before the next auto-stop.
- The driver has not fastened the seatbelt.
- The engine is not running at its normal operating temperature.
- The ambient temperature is under approximately -5 °C (23 °F) or over approximately 37 °C (98 °F).
- Windshield heating is activated.
- The climate system settings and the actual climate in the passenger compartment differ.
- The vehicle is in reverse.
- The driver is making large steering wheel movements.
- The road gradient is very steep.
- The hood is open.
- Driving at high altitude and the engine has not reached its normal operating temperature.
- ABS has been activated.
- Hard braking (even if the ABS system has not been activated).
- Many starts during a short period of time have triggered the starter motor's overheating protection.
- The exhaust system's particulate filter is full.
- A trailer is connected to the vehicle's electrical system.
- The transmission is not running at its normal operating temperature.
- The gear selector is in mode M (±).
- If traffic conditions allow it (for example in a traffic jam).
The engine does not auto-start
The engine will not auto-start after an auto-stop if:
- The driver is not wearing a seat belt, the gear selector is in the P position and the driver's door is open. The engine must be started normally.
The engine auto-starts while the brake pedal is depressed
In the following situations, the engine will auto-start even if the brake pedal is depressed:
- High levels of condensation on the inside of the windows.
- The climate system settings and the actual climate in the passenger compartment differ.
- The brake pedal is pumped repeatedly.
- The hood is open.
- The vehicle begins to roll or increases speed slightly if the engine auto-stopped before the vehicle was at a standstill.
- The driver's seat belt is unbuckled with the gear selector in the D or N positions.
- The gear selector is moved from D to R or M (±).
- The driver's door is opened with the gear selector in D. An audible signal and a text message informs the driver that the ignition is on.
Warning
Do not open the hood if the engine has auto-stopped. Turn off the engine by switching off the ignition before lifting the hood.