Attaching the towing eyelet
Take out the towing eyelet, which is stored in a foam block under the floor in the cargo compartment.
Front: Remove the cover by pressing the cover.
The cover turns along its center line and can then be removed.
Rear: Remove the cover by placing a coin, key or similar at the mark and prying out the cover.
Fold out the cover completely and remove.
Screw the towing eyelet in as far as possible.
Fasten the eyelet securing by, for example, inserting a lug wrench* through it and using this as a lever.
Important
It is important that the towing eye is screwed in securely as far as possible.
To consider before using the towing eyelet
- In certain conditions, the towing eyelet may be used to pull the vehicle onto a flatbed tow truck. The vehicle's position and ground clearance determines if this is possible.
- If the incline of the tow truck is too steep or if the ground clearance under the vehicle is insufficient, attempting to pull it up using the towing eyelet may result in damage.
- If necessary, lift the vehicle using the tow truck's lifting device instead of using the towing eyelet.
Warning
No person or object should be behind the tow truck when the vehicle is lifted onto the bed of the truck.
Important
The towing eyelet is only intended for towing on roads – not for pulling vehicles from ditches or any similar purpose involving severe strain. Call a tow truck for professional assistance.
Removing the towing eyelet
Unscrew the towing eyelet after use and return it to the foam block.
Replace the cover on the bumper.