Shifting gears with automatic transmission

Change gear position by pushing the spring-loaded gear selector forward or rearward, or to the side for manual shifting.

Selecting gears

P6-1917-XC40-Crystal gear shifter + gear selector
Gear selector and gear selector positions overview.

Gear selector positions

Parking – P

P6-1917-XC40H-Crystal gear shifter P
Gear selector and P position overview.

Parking is activated using the P button located next to the gear selector.

In the P position, the transmission is mechanically locked.

Select P position when the vehicle is parked. The vehicle can be started when it is in P position. The vehicle must be stationary when P is selected.

When parking – apply the parking brake before shifting to position P.

 Warning

Always apply the parking brake when parking on an incline. Selecting a gear or putting the automatic transmission in P may not be sufficient to keep the vehicle stationary in all situations.

 Note

The gear selector must be in position P in order to lock the vehicle and set the alarm.

Help functions

The system will switch to the P position automatically:

  • if the ignition is switched off while D or R is selected.
  • if the driver unbuckles the seat belt and opens the driver's door while the vehicle is running with a gear other than P selected.

To park a vehicle with an unbuckled seat belt and open door – end P mode by shifting to R or D again.

If the vehicle is switched off in gear position N, it will not automatically switch to the P position. This makes it possible to wash the vehicle in an automatic car wash.

Reverse – R

Select R when backing up. The vehicle must be stationary when R is selected.

Neutral – N

In N position, the vehicle can roll freely. The vehicle can be started when it is in N position. Apply the parking brake if the vehicle is stationary with the gear selector in the N position.

To move to another gear position when N is selected, the brake pedal must be depressed and the ignition in mode II. For some transmission variants, the engine must be running.

D drive mode

D is the normal driving gear position. The transmission shifts up or down automatically depending on acceleration and speed.

The vehicle must be stationary when the gear selector is moved from R to D.

 Note

To facilitate parking and other low-speed maneuvers, the gear selector can be moved between D and R at very low speeds without depressing the brake pedal.

Manual position – M

P5P6-1917-8G-Gear shift mode M in driver display
Overview of manual gear selector positions in instrument panel.

With position M, it is possible to shift gears manually. Engine braking will occur when the accelerator pedal is released.

M position is selected by moving the gear selector rearward from D.

  • Push the gear selector to the right toward "+" (plus) and release to shift up one gear.
  • Push the gear selector to the left toward "–" (minus) and release to shift down one gear.
  • Push the gear selector rearward to return to D mode.

For smooth shifting and engine performance, the transmission will shift down automatically if the vehicle's speed becomes too low for the selected gear.

Related documents