Using the wireless phone charger*

There is a wireless charger on the rubber pad in the tunnel console that can be used to wirelessly charge Qi-certified or Qi-compatible devices, such as phones.

Activating and deactivating the wireless charger

The charger can be activated and deactivated in the center display. The default mode is that the charger is not activated. When the charger is switched on, a message will appear describing the risks for users with pacemakers or other implanted devices who could be affected by the charger. Tap the center display to confirm that the charger should be switched on.

Go to settings iCup-2037-Settings symbol at the bottom of the center display and then tap Controls.
Activate or deactivate the wireless charger.
Confirm to activate the charger.

Charging a device using the wireless charger

P5-2122-Wireless Phone Charger
Wireless charger in the tunnel console.

 Warning

Wireless charging can affect the operation of an implanted pacemaker or other medical devices. If you have one, it is recommended to consult with your doctor before using the wireless charging system.
Make sure that the charger is activated.
Remove all other objects from the charger.
Place the device to be charged in the center of the charger.
The device will begin charging and the iCup-2037-Wireless phone charging symbol symbol will appear at the top of the center display.

 Important

Do not store cards or other objects with near-field communication (NFC), e.g. debit cards for contactless payment, together with the device to be charged. This interferes with the charging and could damage these types of objects.

 Note

  • The charging process may vary depending on the type of device being charged. For example, the amount of time before charging starts or before the device is fully charged may vary.
  • Devices may become warm during charging. This is normal.

If the device is not charging:

  • Check in the center display that the charger is activated.
  • Make sure there are no other objects on the charger.
  • Make sure the device supports wireless charging (Qi).
  • Lift up the device and then put it back on the center of the charger.
  • Remove all covers and cases from the device.
  • Make sure the ignition is on.
  • Make sure the device has not slid off the charger while driving.
  • If any of the doors are opened, charging will stop for a few seconds.
  • If the temperature of the device becomes too high while charging the charging function will be switched off.
  • Deactivate the NFC (Near Field Communication) feature if the device has this.

If objects on the charger prevent charging, a message will be shown in the center display.

 Important

Keep the device and charger free from other objects while charging to help avoid overheating.
  1. * Option/accessory.