Note
Charging cable (mode 2)1
When charging via a wall outlet, use a charging cable with a control module that can limit the amperage (mode 2).
Warning
Warning
Warning
- The charging cable must be grounded when in use. It is equipped with a cord with a grounding conductor and a grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances and is not damaged in any way.
- Children should be supervised when in the vicinity of the charging cable when it is plugged in.
- High voltage is present in your electric meter housing and power distribution service panel. Contact with high voltage can cause death or serious personal injury.
- Do not use the charging cable if it is damaged in any way. A damaged or malfunctioning charging cable may only be repaired by a workshop – an authorized Volvo workshop is recommended.
- Always position the charging cable so that it will not be driven over, stepped on, tripped over or otherwise damaged, or cause personal injury.
- Disconnect the charger from the wall outlet before cleaning it.
- Never connect the charging cable to an extension cord or a multiple plug socket.
- Do not use one or more adapters between the charging cable and the electric outlet.
- Never connect adapters of any kind between the charging cable and the vehicle.
- Do not use an external timer between the charging cable and the electrical outlet.
Also, refer to the manufacturer's instructions for using the charging cable and its components.
Starting charging
Plug the charging cable into a 120/240 V outlet. Open the charger door and remove the charging socket's protective cover. Note that the ignition must be switched off completely before charging. Remove the charging handle's protective cover and push the handle all the way into the vehicle's socket.
The charging cable handle will lock into place and charging will begin within 5 seconds.
Note
Important
Warning
- The hybrid battery must only be charged at maximum permitted charging current or lower in accordance with applicable local and national recommendations for hybrid charging from wall outlets/plugs.
- Only charge the hybrid battery from approved, grounded wall outlets.
- Avoid visibly worn, defective or damaged electrical outlets since they may lead to fire damage and/or personal injury if used.
Important
Stopping charging
To stop charging of the hybrid battery, unlock the vehicle, unplug the charging cable from the vehicle's charging socket and then unplug the cable from the 120/240 V outlet.
Note
Important
The vehicle must be unlocked before the charging cable is disconnected from the vehicle's charging socket. This must be done even if the vehicle's doors are already unlocked.
If the vehicle is not unlocked, the charging cable or system may be damaged.
Important
- Never unplug the charging cable from the wall outlet while charging is in progress – the wall outlet could be damaged in such circumstances.
- Note that the charging cable must be disconnected from the vehicle's charging socket before it is disconnected from the wall outlet, partly to prevent damage to the system and party to prevent unintentional interruption of charging.
Fuse
Charging a hybrid battery via a wall outlet corresponds to a high load on the fuse.
Important
There are normally several 120/240 V power consumers in one fuse circuit, which means that more than one power consumer (e.g. lighting, vacuum cleaner, electric drill, etc.) may use the same fuse.
Important
Make sure that the 120/240 V outlet has sufficient amperage for charging electric vehicles. If you are uncertain of the capacity, have the outlet checked by a licensed electrician.