Installing and removing the steel cargo grid*
![P5-1717-XC90-Safety grille overview](https://www.volvocars.com/images/support/img14f379f121fcf041c0a801520fb9e9dd_1_--_--_VOICEpnghigh.png?imwidth=1280)
For safety reasons, the steel grid must always be installed and secured correctly.
Warning
The steel grid consists of the grid itself and two separate mounting brackets. Each of the mounting brackets has a screw cover and two plastic sleeves for the grid.
Warning
Warning
Important
Installation
![P5-1507 Protection grid step 1](https://www.volvocars.com/images/support/img50abe6933e1e4e2bc0a8015265e1cc30_1_--_--_VOICEpnghigh.png?imwidth=1280)
Press one of the grid's hooks into the larger hole in the ceiling attachment point (1).
Grasp the grid near the hook and pull/push it into the smaller hole (2).
Warning
![P5-1507 Protection grid step 2](https://www.volvocars.com/images/support/img461777303e1e21fdc0a801523ef78e8e_1_--_--_VOICEpnghigh.png?imwidth=1280)
Attach the mounting bracket's hook through the cargo anchoring eyelet near the floor of the cargo compartment and insert the threaded section of the bracket through the grid's lower attachment hole (1).
Slide the plastic sleeve onto the threaded section of the mounting bracket with the sleeve's flange turned upward and press it down through the hole. Screw the screw cover into place until its underside is approximately 5 mm from the grid (2).
Removing the cover
Remove the steel grid by performing the above steps in reverse order.
It can be a good idea to remove the mounting brackets before removing the plastic sleeves from the holes in the grid.