Make sure that the load cover is facing the right way up. You should be able to grasp the handle on the screen.
Put one end of the load cover into the indentation in the groove on one side of the boot. The indentation is highlighted with a marker line. Make sure that the end of the load cover lines up with the marker line.
Slide the other end of the load cover into the groove until it locks into place.
Note
There are springs at both ends of the load cover. You need to press the end of the load cover against the side of the boot to make it fit into the groove.
Pull the load cover screen by the handle until it is fully extended.
Tilt the outer edge of the load cover downwards so that it locks into position in the grooves.
To remove the load cover, simply carry out the installation steps in reverse order.
Important
It is not advisable to place objects on the load cover. They will not be secure and can cause damage in the event of a collision or sudden braking.
Large objects placed in the boot can obscure the driver's view through the rear windscreen.