Replacing the rear direction indicator bulb

Bulbs for rear direction indicators are located behind the panel in the side of the cargo area.
P6-1746-XC40-Remove rear light panel
  1. 1.Press in the panel hatch at the upper edge to detach it.
  2. 2.Move the insulation aside to access the supporting bridge.
P6-1746-XC40-Remove light support bridge
  1. 3.Unscrew and remove the spring bolt anticlockwise, press the clips into the sides and remove the supporting bridge. It is easiest to allow the screw to remain in the supporting bridge.
P6-1746-XC40-Removing turn signal light bulb
  1. 4.Undo the grey bulb holder by turning it anticlockwise and pulling it out.
  2. 5.Remove the bulb by pressing it in and turning anticlockwise.
  3. 6.Fit a new bulb by pressing it in and turning it clockwise.
  4. 7.Attach the bulb holder by turning it clockwise.
  5. 8.Fit the supporting bridge with associated spring bolt and make sure that the clips align in the correct position. Tighten the spring bolt until it stops, max. 2 Nm (1.5 ft lbs).
  6. 9.Move back the insulation and then hook in the panel and press it back into place.

 Important

Never touch the glass part of the bulbs with your fingers. Grease from your fingers is vaporised by the heat, coating the reflector and then causing damage.