Activating and starting Adaptive Cruise Control

Adaptive cruise control (ACC1) must first be activated and then started if it is to control the speed and distance.

Setting the adaptive cruise control in standby mode

P5-1507-ACC På
NOTE: The illustration is schematic - details may vary depending on car model.
Immediately after the engine is started the Adaptive Cruise Control is in the standby mode. To set it in standby mode from active mode, proceed as follows:
Press steering wheel button ◀ (2) or ▶ (3) to scroll to the symbol/function P5-1507- Symbol(i txt) farthållare 2 (4).
The symbol is displayed and Adaptive Cruise Control is set in standby mode.

Starting/activating the adaptive cruise control

In order to start the ACC the following requirements apply:
  • The driver's seatbelt must be buckled and the driver's door must be closed.
  • There must be a vehicle (the "target vehicle") within reasonable distance in front of the car, or the current speed must be at least 15 km/h (9 mph).
  • For cars with manual gearbox. Speed must be at the lowest 30 km/h (20 mph).
P5-1507-ACC På
NOTE: The illustration is schematic - details may vary depending on car model.
With the symbol/function P5-1507- Symbol(i txt) farthållare 2 (4) displayed, press the steering wheel button P5-1507-Symbol 5x3,5-CC rattknapp Centrum-V (1).
Adaptive cruise control starts and the current speed is stored, which is shown in figures in the centre of the speedometer.
P5-1519-xc90H-Symbol DA

The time interval is only adjusted to the vehicle ahead by the ACC when the distance symbol shows two vehicles.

P5-1507-ACC Hastighet skillnad

At the same time a speed range is marked.

The higher speed is the stored/selected speed and the lower speed is that of the vehicle ahead (target vehicle).

  1. 1 Adaptive Cruise Control