Key positions - functions at different levels
To enable the use of a limited number of functions with the engine switched off, the car's electrical system can be set in 3 different levels (key positions) - 0, I and II - with the remote control key. This owner's manual describes these levels throughout using the denomination "key positions".
The following table shows the functions available in each key position/level.
Level | Functions |
---|---|
0 |
|
I |
|
II |
This key position consumes a lot of current from the starter battery and should therefore be avoided! |
Selecting key position/level
- Key position 0 - Unlock the car - This means that the car's electrical system is at level 0.
- Key position I - With the remote control key fully inserted into the ignition switch1 - Briefly press START/STOP ENGINE.
Note
To reach level I or II without starting the engine - do not depress the brake/clutch pedal when these key positions are due to be selected.
Audio system
For information on audio system functions with remote control key removed, see the Sensus Infotainment supplement.
Starting and stopping the engine
For information about starting/stopping the engine, see Starting the engine.
Towing
For important information about the remote control key during towing, see Towing.