Fitting the towing eye
Take out the towing eye from the foam block under the floor in the cargo area.
Front: Remove the cover – press the lid.
The cover pivots around its centre line and can then be removed.
Rear: Remove the cover – Use a coin, key or similar to pry the lid out using the marking.
Fold out the cover completely and detach.
Screw in the towing eye until it reaches its end stop.
Screw the eye in firmly. For example, thread through the wheel bolt wrench* and use it as a lever.
Important
It is important that the towing eye is firmly screwed into place - right in until it stops.
Removing the towing eye
Unscrew and remove the towing eye after use and return it to its foam block.
Finish by refitting the cover onto the bumper.