Using a warning triangle
Assemble and set out a warning triangle if your car is immobilised in an area where there might be other vehicles. The warning triangle's purpose is to give other drivers advance notice of your car or other stationary hazards.
Note
Local rules and regulations
Rules and regulations about how and when to put out a warning triangle vary between regions. You are responsible for knowing and following what applies in your location.
Tip
- If it's dark when you set out the warning triangle, wear a reflective vest if you have one. If you don't have one, you can hold the warning triangle so that its reflective parts are visible as you carry it.
- You can place the case on the driver's seat as a reminder to retrieve the warning triangle when you leave.
Activate the hazard warning lights.
The warning triangle is located on the inside of the boot hatch. Open the compartment by turning the handle so that it's vertical and then pulling it.
Take out the warning triangle from its case, unfold it and connect its ends.
Fold out the triangle's support legs.
Position the warning triangle in a suitable place in regard to traffic and at a distance which ensures that other drivers are alerted in good time before they reach your car.
Remember to retrieve the warning triangle before you drive off again.