Tehniskā specifikācija
Bezvadu lādētājs un NFC lasītājs ir paredzēts darbam apkārtējās vides temperatūrā no -35 °C līdz 85 °C.
- Frekvenču josla: 127,7 ± 10 kHz
- Maksimālais magnētiskā lauka stiprums: 65,69 dBμA/m 10 m attālumā
- Frekvenču josla 13,56 MHz ±10 %
- Maksimālais magnētiskā lauka stiprums: 42 dBμA/m 10 m attālumā
Atbilstības deklarācija
CE RED | Ar šo Hefei Invispower Co., Ltd deklarē, ka radioiekārta NFCR-INTERNAL (modelis: NFC-I-SX-21548) un bezvadu uzlādes modulis (modelis: WPC-15SN-21493) atbilst Direktīvas 2014/53/ES prasībām. Šī aprīkojuma maksimālais pieļaujamais iedarbības līmenis (MPE) ir balstīts uz d=20 cm attālumu starp aprīkojumu un cilvēka ķermeni. Lai ievērotu prasības attiecībā uz RF iedarbību, ir ieteicams lietošanas laikā saglabāt vismaz 20 cm attālumu starp aprīkojumu un ķermeņa daļām. |
UKCA | Hereby, Hefei Invispower Co.,Ltd declares that the radio equipment NFCR-INTERNAL (model: NFC-I-SX-21548) and Model-Wireless charging (model: WPC-15SN-21493) are in compliance with UK Radio Equipment Regulations (SI 2017/1206). |
FCC ID & IC | This device complies with part 15 of the FCC rules and with RSS-Gen,RSS-216 rules of Canada. Operation is subject to the following two conditions:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
IDéclaration d'avertissement ISED Son fonctionnement est soumis aux deux conditions suivantes:
Les changements ou modifications non expressement approuves par la partie responsable de la conformité peut annuler l'autorite de l'utilisateura utilizer l'equipement. Déclaration d'exposition aux radiations RF de l'ISED: Cet équipement est conforme aux limites d'exposition aux rayonnements RF de l'ISED définies pour un environnement non contrôlé. Cet appareil et son antenne ne doivent pas être situés ou fonctionner conjointement avec une autre antenne ou un autre émetteur |
ANATEL | This equipment is not entitled to protection against harmful interference and may not cause interference to properly authorized systems. For more information, see the ANATEL website – https://www.gov.br/anatel Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados. Para maiores informações, consulte o site da ANATEL – https://www.gov.br/anatel |
Ķīna (SRRC) | (一)符合“微功率短距离无线电发射设备目录和技术要求”的具体条款和使用场景,采用的天线类型和性能,控制、调整及开关等使用方法; (二)不得擅自改变使用场景或使用条件、扩大发射频率范围、加大发射功率(包括额外加装射频功率放大器),不得擅自更改发射天线; (三)不得对其他合法的无线电台(站)产生有害干扰,也不得提出免受有害干扰保护; (四)应当承受辐射射频能量的工业、科学及医疗(ISM)应用设备的干扰或其他合法的无线电台(站)干扰; (五)如对其他合法的无线电台(站)产生有害干扰时,应立即停止使用,并采取措施消除干扰后方可继续使用; (六)在航空器内和依据法律法规、国家有关规定、标准划设的射电天文台、气象雷达站、卫星地球站(含测控、测距、接收、导航站)等军民用无线电台(站)、机场等的电磁环境保护区域内使用微功率设备,应当遵守电磁环境保护及相关行业主管部门的规定; (七)禁止在以机场跑道中心点为圆心、半径5000米的区域内使用各类模型遥控器; (八)微功率设备使用时温度和电压的环境条件。 |
Meksika | La operación de este equipo está sujeta a las siguientes dos condiciones :(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia , incluyendo la que pueda causar su operación no deseada |
Taizeme |