V60 Trip computer - digital combined instrument panel

The information from the trip computer can be shown in the combined instrument panel and operated with the controls on the left-hand stalk switch and with the combined instrument panel's menu.

Checking and settings can be made immediately after the combined instrument panel is automatically illuminated in connection with unlocking. If none of the trip computer's controls are actuated within approx. 30 seconds after the driver's door has been opened then the instrument extinguishes, after which either key position II or engine starting is required in order to operate the trip computer.

Note

If a warning message appears when the trip computer is used then the message must first be acknowledged before the trip computer can be reactivated.

Acknowledge the message by briefly pressing the indicator stalk OK button.

Controls

P4-1246-Färddator High — Three trip computer options can be displayed simultaneously - one in each "window".

Ikon röd cirkel 1 — Three trip computer options can be displayed simultaneously - one in each "window".

Trip comp. opt.

Choose which trip computer should be shown:

To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.

Turn the thumbwheel to browse between the heading combinations.

Stop at the required combination for the constant display of this trip data in the combined instrument panel.

The trip computer display in the combined instrument panel can be shifted to another option at any time during the journey. One of the options means that no trip computer is shown.

Heading combinations			Information

Average	Trip meter T1 + Meter reading	Average speed	Long press on RESET resets trip meter T1.
Instantaneous	Trip meter T2 + Meter reading	Distance to empty tank	Long press on RESET resets trip meter T2.
Instantaneous	Meter reading	kmh<>mph	kmh<>mph - see section "Digital speed display".
	No trip computer information.		This option extinguishes all three trip computer displays and it also indicates the beginning/end of the loop.

Resetting the trip computer

Trip meter

Turn the thumbwheel and stop at the heading combination with the trip meter to be reset.

One long press on RESET resets the value for the selected heading.

Average speed and average consumption

Press OK to open the combined instrument panel's menu.

Browse to the Trip computer reset menu option with the thumbwheel and confirm with OK.

Choose to reset average consumption, average speed or to reset both. Confirm the selection with OK.

Finish by pressing RESET.

Functions in the combined instrument panel's menu

The combined instrument panel's menu includes setting options for trip computer. Open the menu to check/adjust the functions in the table below.

To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.

Press OK.

Browse through the functions with the thumbwheel and select/confirm with OK.

Finish by pressing twice on RESET after completed checking/adjustment.

Functions	Information
Trip computer reset Average Average speed	Reset the value of average fuel consumption and average speed. Note that this function does not reset both trip meters T1 and T2.
Messages	For more information, see Messages - handling.
Themes	Select the theme for the appearance of the combined instrument panel.
Settings*	Select Auto On or Off. For more information, see Additional heater *.
Contrast mode/Colour mode	Adjusting the combined instrument panel's brightness and colour intensity.
Parking heater* Direct start - Symbol Timer 1 - leads to the menu for selecting time. - Symbol Timer 2 - leads to the menu for selecting time.	For a description of programming the timer, see Engine block heater and passenger compartment heater * - timer.
Service status	Shows the number of months and mileage to next service.
Oil level1	For more information, see Engine oil - checking and filling.