Cars with the Start/Stop function are equipped with two 12 V batteries - one extra powerful starter battery for starting and one support battery that helps during the Start/Stop function's starting sequence.
For more information on the Start/Stop function, see Start/Stop*.
For more information on the car's starter battery, see Jump starting with battery.
The following table shows specifications for the starter battery and support battery respectively in cars with Start/Stop function.
Important
Note
- The higher the current take-off in the car, the more the alternator must be working and the batteries charging = Increased fuel consumption.
- When the capacity of the starter battery has fallen below the lowest permissible level then the Start/Stop function is disengaged.
Temporarily reduced Start/Stop function due to high current take-off means:
- The engine starts automatically9 without the driver depressing the clutch pedal (manual gearbox).
- The engine starts automatically without the driver lifting his/her foot off the foot brake pedal (automatic gearbox).
Location of the batteries
Starter battery10
Support battery
The support battery normally requires no more service than the normal starter battery. A workshop should be contacted in the event of questions or problems - an authorised Volvo workshop is recommended.
Important
If the following instruction is not observed then the Start/Stop function may temporarily cease to work after the connection of an external battery or battery charger:
- The negative battery terminal on the car's starter battery must never be used for connecting an external battery or battery charger - only the car chassis may be used as the grounding point.
See Jump starting with battery for a description of how the cable clamps must be attached.
Note
If the battery has become so discharged that everything is "black" and in principle the car does not have all the normal electrical functions and the engine is subsequently started using an external battery or battery charger, then the Start/Stop function will be activated. It will then be possible for the engine to be auto-stopped but in the event of an auto-stop the Start/Stop function may fail to auto-start the engine due to inadequate capacity in the battery.
The battery must first be charged in order to ensure a successful auto-start after an auto-stop. At an outside temperature of +15 °C the battery needs to be charged for at least 1 hour. At a lower outside temperature a charging time of 3-4 hours is recommended. The recommendation is that the battery is charged using an external battery charger.
If this is not possible then the recommendation is to temporarily deactivate the Start/Stop function until the battery has been adequately recharged.
For more information on charging the starter battery, see Starter battery - general.