V60 Trip computer - analogue combined instrument panel

The information from the trip computer can be shown in the combined instrument panel and operated with the controls on the left-hand stalk switch and with the combined instrument panel's menu.

Checking and settings can be made immediately after the combined instrument panel is automatically illuminated in connection with unlocking. If none of the trip computer's controls are actuated within approx. 30 seconds after the driver's door has been opened then the instrument extinguishes, after which either key position II or engine starting is required in order to operate the trip computer.

Note

If a warning message appears when the trip computer is used then the message must first be acknowledged before the trip computer can be reactivated.

Acknowledge the message by briefly pressing the indicator stalk OK button.

Controls

P4-1246-Färddator Low — Information display and controls.

Ikon röd cirkel 1 — Information display and controls.

Trip comp. opt.

Choose which trip computer should be shown:

To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.

Turn the thumbwheel to browse between the options and stop at the required heading.

The trip computer display in the combined instrument panel can be shifted to another option at any time during the journey. One of the options means that no trip computer is shown.

Trip computer heading in combined instrument panel	Information
Trip meter T1 and total dist.	Long press on RESET resets trip meter T1.
Trip meter T2 and total dist.	Long press on RESET resets trip meter T2.
Distance to empty	For more information - see the section "Range - distance to empty tank".
Fuel consumption	Current consumption.
Average speed	Long press on RESET resets Average speed.
No trip computer information.	This option shows a blank display and it also indicates the beginning/end of the loop.

Resetting the trip computer

Turn the thumbwheel and stop at the trip computer heading to be reset: T1 and total dist., T2 and total dist. or Average speed.

One long press on RESET resets the value for the selected heading.

Each heading must be zeroed individually.

Functions in the combined instrument panel's menu

The combined instrument panel's menu includes setting options for trip computer. Open the menu to check/adjust the functions in the table below.

To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.

Press OK.

Browse through the functions with the thumbwheel and select/confirm with OK.

Finish by pressing twice on RESET after completed checking/adjustment.

Functions	Information
Digital speed km/h mph No display	Shows the car's speed digitally in the centre of the combined instrument panel.
Parking heater* DIRECT START - Timer 1 - leads to the menu for selecting time. - Timer 2 - leads to the menu for selecting time.	For a description of programming the timer, see Engine block heater and passenger compartment heater * - timer.
Additional heater* Auto On Off	For more information, see Additional heater *.
TC options Distance to empty tank Fuel consumption Average speed Trip meter T1 and total dist. Trip meter T2 and total dist.	Here you can activate the options that you want to be available as selectable headings in the trip computer. The symbols for the options already selected are white with a "tick" - others are grey and have no "tick".
Service status	Shows the number of months and mileage to next service.
Oil level1	For more information, see Engine oil - checking and filling.
Messages (##)	For more information, see Messages - handling.