Opening and closing the bonnet

The bonnet can be opened using the handle in the passenger compartment and a handle under the bonnet.

Open the bonnet

P6-1746-XC40-Opening hood from inside
P5-Icon red arrow 1Pull the handle near the foot pedals to release the bonnet from its fully closed position.
P6-1746-XC40-Opening hood with outer handle
P5-Icon red arrow 2Move the handle under the bonnet upwards to release the bonnet from the lock catch and lift the bonnet.
P6-1746-XC40-Support rod for opening hood
P5-Icon red arrow 3Use the support pin to hold the bonnet raised and attach it securely.

Warning - bonnet not closed

P5-1507 Symbol General red

When the bonnet is released, the warning symbol and the graphics in the driver display will light up and an acoustic reminder will sound. If the car starts rolling, an acoustic warning signal will repeat.

 Note

If the warning symbol is lit or the warning signal is heard despite the bonnet being closed properly, contact an authorised Volvo workshop.

Close the bonnet

Detach the support pin and secure it in its place.

P6-1746-XC40-Storing the support rod for hood
Lower the bonnet manually.
When the bonnet stops against the lock catch, push the bonnet to close it completely.

 Warning

Risk of crushing! Ensure that the closing path under the bonnet is not obstructed, otherwise there is a risk of personal injury.

 Warning

Check that the bonnet locks properly when closed. The bonnet must engage at both sides audibly.
P5-1617-S90/V90 Hood, slightly open
Bonnet not completely closed. The figure is schematic - parts may vary depending on car model.
P5-1617-S90/V90 Hood, closed
Bonnet completely closed. The figure is schematic - parts may vary depending on car model.

 Warning

Never drive with an open bonnet!

If there are any signs that the bonnet is not properly closed whilst driving, stop immediately and close it.