XC90 Twin Engine Ignition positions

In order to facilitate the use of a limited number of functions with the engine switched off, the car's electrical system can be set in 3 different levels - 0, I and II. These levels are described with the denomination "ignition position" throughout the owner's manual.

The following table shows the functions available in each ignition position/level:

Level	Functions
0	Odometer, clock and temperature gauge are illuminated. Power seats can be adjusted. The power windows can be used. The centre display is started and can be used. It is possible to start the audio. The functions are time-controlled in this ignition position and are switched off automatically after a period of time.
I	Panorama roof, power windows, 12V socket in the passenger compartment, navigation, phone, ventilation fan and windscreen wipers can be used. Power seats can be adjusted. 12 V sockets in the cargo area can be used. The audio is started automatically if it was running when the car was left. Current consumption loads the starter battery in this ignition position.
II	The headlamps come on. Warning/indicator lamps illuminate for 5 seconds. Several other systems are activated. However, heating in seat cushions and the rear window can only be activated after the engine has been started. This ignition position consumes a lot of current from the starter battery and should therefore be avoided!

Selecting ignition position

P5-1507-Start/switch off engine — Ignition dial in the tunnel console.

Ignition position 0 - Unlock the car and store the remote control key inside the car.

Note

To reach level I or II without starting the engine, do not depress the brake pedal when these ignition positions are to be selected.

Ignition position I - Turn the ignition dial to START and release it. The control automatically returns to its starting position.
Ignition position II - Turn the ignition dial to START and hold it in the START position for approx. 4 seconds. Then release the knob, which automatically returns to its starting position.
Back to ignition position 0 - To return to ignition position 0 from position I and II - Turn the ignition dial to STOP and release it. The control automatically returns to its starting position.