Driving with start/stop function
The Start/Stop function is available when the car is started and can be activated if certain conditions have been met.
- Available
- active
- not available.
All of the car's normal systems such as lighting, radio, etc. work normally, even when the engine is auto-stopped. However, some equipment may have its output temporarily reduced, e.g. the climate control system's fan speed or extremely high volume on the audio system.
Auto-stop
The following is required for the engine to auto-stop:
- Stop the car with the foot brake and then keep your foot on the brake pedal - the engine stops automatically.
In drive mode Comfort or Eco, the engine may auto-stop before the car is completely stationary.
With adaptive cruise control or Pilot Assist activated, the engine will auto-stop after approximately 3 seconds.
Autostart
The following is required for the engine to auto-start:
- Release the brake pedal - the engine will autostart and you can continue driving. On an uphill gradient hill start assist (HSA1) engages, which prevents the car from rolling backwards.
- When the Auto Hold function is activated, auto-start is delayed until the accelerator pedal is depressed.
- When adaptive cruise control or Pilot Assist is activated, the engine will auto-start when the accelerator pedal is depressed, or by pressing the
button on the left keypad of the steering wheel.
- Maintain foot pressure on the brake pedal and depress the accelerator pedal - the engine auto-starts.
- On a downhill gradient: Release pressure on the brake pedal slightly so that the car begins to roll - the engine will auto-start after a slight speed increase.
Symbols in the driver display
With 12-inch driver display*
- The text READY is shown in the tachometer when the function is available.
- A pointer in the tachometer points to READY when the function is active and the engine is auto-stopped.
- The text READY is greyed out when the function is not available.
- No text is shown when the function is deactivated.
![P5-1507-StartStop READY symbol in gauge](https://www.volvocars.com/images/support/img592b8261ae229746c0a801524e370399_1_--_--_VOICEpnghigh.png?imwidth=1280)
With 8-inch driver display
The symbol is shown in the lower edge of the speedometer.
Symbol | Specification |
---|---|
![]() | White symbol: The function is available. |
![]() | Beige symbol: The function is active and the engine is auto-stopped. |
![]() | The function is not available, the conditions are not fulfilled. |
No symbol is shown when the function is deactivated. |