Procedure to temporarily change the automatic high beam sensitivity

You can set an alternative automatic high beam sensitivity in accordance with FMVSS108 requirements.

 Note

The car must be stationary to perform the sensitivity change. Keep the brake pedal pressed down throughout the procedure.
Put the car in drive by selecting D with the right-hand steering wheel stalk.
Make sure that the automatic lights mode is selected with the rotating ring on the left-hand steering wheel stalk.

The following steps must be completed within 20 seconds:

Select the auto high beam with the rotating ring on the left-hand steering wheel stalk.
The rotating ring springs back to the automatic lights mode .
Repeat the previous step twenty times.

 Note

The sensitivity returns to the default setting when you start a new drive cycle.