![P3-1020-V70/XC70 Tire sealing kit](https://www.volvocars.com/images/support/img7c1e7140ece3bdf0c0a801e701d668ae_1_--_--_VOICEpnghigh.png?imwidth=1280)
Introduction
The tire sealing system consists of an air compressor, a container for the sealing compound, wiring to connect the system to the vehicle’s electrical system via one of the 12-volt sockets, and a hose used to connect the system to the tire’s inflation valve.
Note
The tire sealing system's compressor has been tested and approved by Volvo.
The 12-volt sockets are located in the front tunnel console, on the rear side of the center console in the rear seat and in the cargo area*.
Accessing the tire sealing system
The tire sealing system is stowed under the floor of the cargo area. To access it:
- Lift the floor hatch in the cargo area.
- Lift out the tire sealing system.
Note
- The tire sealing system is only intended to seal holes on the tire’s tread area, not the sidewall.
- Tires with large holes or tears cannot be repaired with the tire sealing system.
- After use, stow the tire sealing system properly to help prevent rattling.
Warning
- After using the tire sealing system, the vehicle should not be driven farther than approximately 120 miles (200 km).
- Have the tire inspected by a trained and qualified Volvo service technician as soon as possible to determine if it can be permanently repaired or must be replaced.
- The vehicle should not be driven faster than 50 mph (80 km/h) while using a tire that has been temporarily repaired with the tire sealing system.
- After using the tire sealing system, drive carefully and avoid abrupt steering maneuvers and sudden stops.
Tire sealing system–temporarily repairing a flat tire
![P3/P4-1246-ALL- new version of TMK 2](https://www.volvocars.com/images/support/img8c87e2ab4904a53fc0a801e700fcc5f9_1_--_--_VOICEpnghigh.png?imwidth=1280)
Temporarily repairing a flat tire is done in two stages:
- Stage 1: The hole is sealed by pumping sealing compound into the tire. The car is then driven a short distance to distribute the sealing compound in the tire.
Note
Do not remove any foreign objects (nails, etc.) from the tire before using the sealing system.
- Stage 2: The tire’s inflation pressure is checked and adjusted if necessary.
Warning
- Never leave the tire sealing system unattended when it is operating.
- Keep the tire sealing system away from children.
- Be sure the vehicle is parked safely off the road and away from moving traffic.
- Apply the parking brake.