Operating the power windows

All power windows can be operated using the control panel in the driver's door. The control panels in the other doors only operate the window in the respective doors.

 Warning

  • Always put the ignition in mode 0 and remove the ignition key from the vehicle when the vehicle is unattended
  • Never leave children unattended in the vehicle.
  • Make sure that the windows are completely unobstructed before they are operated.

Operating

P5-1507 Driver's door control panel - operating
Operating the power windows
  1. P5-Icon red arrow 1Manual up/down
  2. P5-Icon red arrow 2Auto up/down.

For the power windows to function, the ignition must be in at least mode I. When the vehicle has been running, the power windows can be operated for several minutes after the ignition has been switched off, or until a door has been opened.

 Note

  • Movement of the windows will stop if they are obstructed in any way. If this happens twice in succession, the automatic function will not work for several minutes and the window can be closed by holding the button up.
  • To reduce buffeting wind noise if the rear windows are opened, also open the front windows slightly.

Manual up/down

Move one of the controls up/down slightly.
The power windows move up/down as long as the control is held in position.

Auto up/down

Move one of the controls up/down as far as possible and release it.
The window will open or close completely.

Resetting

If the battery has been disconnected, the auto open function must be reset so that it will work properly
Gently raise the front section of the button to close the window and hold it for one second.
Release the button briefly.
Raise the front section of the button again for one second.