The boot hatch cover is installed on the inside of the boot hatch, just below the rear window. When the load cover is fully extended and the boot hatch cover is installed, the whole boot storage compartment is covered.
When installing the boot hatch cover, make sure it is the right way up. The side of the cover with the screw heads visible should be facing down.
Installing the boot hatch cover
Guide one of the pins on the boot hatch cover into the bracket on one side of the boot hatch.
Squeeze the cover together slightly while guiding the second pin into the bracket on the other side of the boot hatch.
Push the two clips on the long side of the boot hatch cover upwards and click them into place on the boot hatch.
The boot hatch cover is installed and covers the boot storage compartment.
Note
Although it is not recommended, you can remove the boot hatch cover if necessary. To do this, just follow the installation steps in reverse order. Be sure to store it safely after removing it.