Bulb replacement
The bulbs in the halogen headlamp can be replaced without the help of a workshop, but the plastic cover over the headlamp must be removed before the bulbs can be replaced.
Lift off the rubber strip by pressing it inward in the engine compartment.
Release the pins in the plastic cover's four clips by pressing down the pins with a screwdriver or similar and removing the cover.
Refit the cover in reverse order.
Note
The pins in the clips need to be pressed back completely before the clips are refitted in the cover.
When the cover is refitted the pins must be pressed in until their end surfaces are level with the surfaces of the clips.
The dipped beam bulb becomes accessible when the headlamp's round rubber cover is removed.
Bulbs for the direction indicator, main beam and the daytime running light/position lamp become accessible when the headlamp's oval cover is removed.
Contact a workshop1 if faults occur in other lamps. This also applies to the bulbs for reversing lights. If a fault occurs in LED2 lamps, the entire lamp unit usually must be replaced.