Note
For information about bulbs not covered in this article, contact a Volvo dealer or a certified Volvo service technician.
The bulb in the halogen headlamp can be replaced without the help of a workshop, but the plastic cover over the headlamp must be removed before a bulb can be replaced.
The dipped beam bulb becomes accessible when the headlamp's round rubber cover is removed.
Bulbs for direction indicator, main beam and daytime running light/position lamp are accessible when the headlamp's oblong cover is loosened.
Contact a workshop2 if faults other than bulbs occur in lamps. If a fault occurs in LED1 lamps, the entire lamp unit usually must be replaced.
Warning
The car's electrical system must be in ignition position 0 when replacing bulbs.
Important
Never touch the glass part of the bulbs with your fingers. Grease from your fingers is vaporised by the heat, coating the reflector and then causing damage.
Note
If an error message remains after the broken bulb has been replaced then we recommend visiting an authorised Volvo workshop.
Note
Outside lighting such as headlamps and rear lamps may temporarily have condensation on the inside of the lens. This is normal, all exterior lighting is designed to withstand this. Condensation is normally vented out of the lamp housing when the lamp has been switched on for a time.