Perform the following procedure to store a new tyre pressure as a reference value in the system:
Switch off the car.
Inflate the tyres to the correct pressure, see the decal on the door pillar on the driver's side showing the recommended pressure for factory fitted tyres.
Start the car.
Open the Car Status app in the app view.
Press TPMS.
Press Store Pressure.
Note
The Store Pressure button is used to save new reference values for tyre pressures in the tyre pressure monitoring system. For safety reasons, it is only available (selectable) when the car is stationary and the engine is running.
Tap on OK to confirm that the tyre pressure in all four tyres has been checked and adjusted.
Note
To avoid mistaken activation of the Store Pressure function, it is necessary to confirm in a second step that the tyre pressure should be saved.
Drive the car until the new tyre pressure has been saved. The new tyre pressure is stored when the car is driven at a speed above 35 km/h (22 mph).
When sufficient data have been collected for the system to be able to detect low tyre pressure, the animation showing the progress of storing the new reference value disappears from the centre display. The system does not provide additional confirmation that a new tyre pressure has been saved.
If storing fails, a message is shown.
Warning
The exhaust gases contain carbon monoxide, which is invisible and odourless, but highly toxic. The procedure to save a new tyre pressure must therefore always be performed outdoors or in a workshop with exhaust extraction.