Ending charging of an electric car

End charging at any time by pressing the button next to the charging input socket or via the button in the centre display.

Ending charging (alternating current)1

Press the button next to the charging input socket, or via the button in the centre display – the charging cable's locked handle releases/is unlocked.

 Important

Charging must be ended before unplugging the charging cable from the car's charging input socket. If charging is not ended before the charging cable is disconnected, this may lead to damage to the charging cable or to the system.

2139-BEV-Stop charging- rear inlet and charging gun

Unplug the charging cable from the car's charging input socket and close the hatch.

Unplug the charging cable from the charging station, or plug the permanent charging cable into the charging station’s storage socket.

The charging cable is locked automatically

If the charging cable is not unplugged from the charging input socket, it is automatically locked in again shortly after unlocking in order to maximise the charging. The charging cable can be unplugged again using the button next to the charging input socket or via the button in the centre display.

Ending fast charging (direct current)

 Important

Never try to unplug the charging cable from the car while charging is in progress. Always interrupt charging first and then unplug the charging cable when the lock in the car's charging input socket has been automatically unlocked.

End fast charging by pressing the button next to the car's charging input socket, via the button in the centre display, or via the charging station's user interface.
Charging is ended and the lock in the charging input socket is unlocked automatically. This may take a couple of seconds.
Unplug the charging cable from the car's charging input socket and close the hatch.
Connect the charging cable to the charging station's storage socket or hang it back in the designated location.

Interrupted fast charging

If fast charging is interrupted, it is not resumed automatically as the charging station requires charging to be reauthorised via the user interface. The charging cable will not lock automatically into place if fast charging is interrupted. To restart interrupted fast charging, unplug the charging cable from the car's charging input socket, plug it in again and follow the instructions in the charging station's user interface.

In the event of problems releasing the charging handle

If the charging cable is left in the charging input socket for a while after charging has finished, the charging cable is automatically locked in again2. Therefore, first try to end the charging again. If the charging handle still does not release automatically, proceed as follows:

  • Make sure that the key is within range and that the car is unlocked.
  • Switch off the power supply to the charging station in a safe manner. During charging via a charging station, contact the customer service for the charging station for assistance to end charging.
  • Carefully wiggle the charging handle.
  • Lock and unlock the car.
  • Lock the car and wait until the LED lamp at the car's charging input socket extinguishes. This can take up to 7 minutes. Then unlock the car.

If the problem persists, contact your Volvo dealer.

Unplugging the charging cable with the emergency release handle

If the charging cable cannot be unplugged from the car's charging input socket after charging is complete and the car is equipped with an emergency release handle, follow the instructions below or contact your Volvo dealer.

For cars without an emergency release handle – contact the charging station's customer care or your Volvo dealer.

iCup-24w46-release wire no sticker
Open the car's cargo area and fold up the load floor. Lift away the recessed floor panel.
The emergency release handle is located to the left, under the floor panel.

 Warning

Before using the emergency release handle, check in the driver display that charging is complete. Do not use the emergency release handle while charging is in progress.
Grip and pull the emergency release handle.
The emergency release handle returns automatically the next time charging starts.
Wait approximately 5 seconds before unplugging the charging cable from the car's charging input socket.
Refit the floor panel and fold down the load floor. Close the car's cargo area.
  1. 1 Refers to charging with a mode-3 charging cable, or a charging station with a permanent charging cable.
  2. 2 Applies when charging with alternating current.