Lamp replacement - headlamps
All of the headlamp bulbs are replaced via the engine compartment. First loosen and remove the whole headlamp.
Removing the headlamp
Set the car's electrical system in key position 0, see Key positions - functions at different levels.
 | Pull out the headlamp's locking pins. |
 | Release the headlamp by alternately tilting and pulling it out. |
Important
Do not pull the electrical cable, only the connector.
 | Detach the headlamp connector by pressing down the clip with your thumb. |
 | At the same time, guide out the connector with your other hand. |
| 5. | Lift out the headlamp and place it on a soft surface to avoid scratching the lens. |
| 6. | Replace the bulb in question. |
Securing the headlamp
Plug in the connector, a clicking sound should be heard.
Reinstall the headlamp and locking pins. The short pin is fitted closest to the grille. Check that they are correctly inserted.
Check the lighting.
The headlamp must be mounted and the connector correctly installed before the lighting is switched on or the remote control key is inserted into the ignition switch.